11540.16
Jeep
® JK Wrangler Modular HD Stainless Front Bumper Hoop
Contents:
1. Stainless Hoop (1)
2. Stainless 8mm Washer (8)
3. Stainless 8mm Bolt (8)
1. Center Section of Modular HD Bumper should already be installed on vehicle. If hoop is replacing a
different style of hoop, remove it such that you are left with empty top holes, as shown in Figure 1.
Figure 1
2. Position Hoop over the Center Section, aligning the holes in the Hoop with the holes in the top of the
Center Section (Figure 2a). Note that the Hoop can be installed leaning back or leaning forward,
depending on the desired look (Figure 2b). Start all bolts, but do not tighten them.
Page 1 of 2
3
2
1
Figure 2a Figure 2b
Leaning Back Leaning Forward
Komentarze do niniejszej Instrukcji